Not every project goes as well as planned. We would be happy to spend a few minutes answering your questions.
Current Articles | RSS Feed
Repairing a lever-style bathtub drain stopper can be a challenge. Rather than doing that, you can replace the pop-up assembly with a retrofit assembly. I use a Flip-It drain stopper for this situation.
Lever style assemblies involve removing the linkages and cleaning out the insert that rides up-and-down in the overflow. This is a dirty pain. There is no easy way, and you have to phenagle the linkages out very carefully. Once you repair the problem, you have to get it back into the hole and adjust it until it holds water.
With the Flip-it, you just add the correct size o-rings and push it into the drain. You get a variety of o-rings to fit different sized drain openings. there are two o-rings that go an the base of the Flip-it. These hold the unit in place and stop water from leaking around the perimeter of the unit. Pick the right size o-rings and just push it into the drain.
On top of the unit is a small lever that you toggle to either stop the bathtub water from draining, or to allow the water to drain. They come in a variety of finishes to match most bathtub flanges, and the job should take under 5 mintes.
Allowed tags: <a> link, <b> bold, <i> italics